Energy and exergy analysis of gas turbine cycle combined with a solid oxide fuel cell

Document Type : Research Paper

Authors

tehran university

Abstract

This paper present a gas turbine cycle combined with a solid oxide fuel cell with hydrogen fuel’s is exergy and energy modeled. In this way all components of the system are separately modeled. Fuel cell model presented, as well as show its behavior in different condition performance. Then, the effects of various parameters on efficiency, exergy was evaluated. And for accuracy, the results were compared with results of references and shows a good match. Increasing the turbine inlet temperature results in decreasing the thermal and exergy efficiency of hybrid system, whereas it improves the net power output. Moreover, an increase in the turbine inlet temperature leads to increases irreversibility and compression ratio leads to decreases irreversibility of the hybrid system. The results in the design point showed that 81% of irreversibility takes place in the fuel cell and combustion chamber(41% in the SOFC and 40% in combustion chamber). Hybrid system efficiency is 58.4%, while the system without SOFC efficiency is 31%, that is a combination of superior performance system.

Keywords


[1] Reijalt M., "Hydrogen and fuel cell education in Europe: from when? And where? To here! And now", Journal
of Cleaner Production, vol. 19, 2010.
[2] Williams M.C., Fuel Cell Handbook, 7th edition, EG&G Services Parsons, Science Applications International
Corporation, Morgantown, 2004.
[3] Casas Y., Dewulf J., Arteaga-Perez L., Morales M., Langenhove H.V., Rosa E., "Integration of solid oxide
fuel cell in a sugar-ethanol factory: analysis of the efficiency and the environmental profile of the
products", Journal of Cleaner Production vol. 19, 2011, pp. 1395-1404.
[4] Massardo AF., Lubelli F., "Internal reforming solid oxide fuel cell–gas turbine combined cycles (IRSOFCGT)",
Transactions of the ASME. J Eng Gas Turbines Power, 2000, PP. 27–35.
[5] Costamagna P., Magistri L., Massardo A.F., "Design and part-load performance of a hybrid system based on
a solid oxide fuel cell reactor and a micro gas turbine", Journal Power Sources, 2001, PP. 352–368.
[6] Chan S.H., Ho H.K., Tian Y. "Modelling of simple hybrid solid oxide fuel cell and gas turbine power plant", Journal Power Sources, 2001, PP. 111-120.
[7] Chan S.H., Ho H.K., Tian Y., "Multi-level modeling of SOFC–gas turbine hybrid system", Int Journal Hydrogen Energy, 2002, PP. 889-900.
[8] Yang W.J., Park S.K., Kim T.S., Kim J.H., Sohn J.L., Ro S.T., "Design performance analysis of pressurized solid oxide fuel cell/gas turbine hybrid systems considering temperature constraints", Journal Power Sources, 2006, PP. 462–473.
[9] Park S.K., Oh K.S. and Kim T.S., "Analysis of the design of a pressurized SOFC hybrid system using a fixed gas turbine design", Journal Power Sources, 170(1), 2007, PP.130–139.
[10] Dincer, I., Rosen, M. A., "Exergy as a driver for achieving sustainability", International Journal of Green Energy, 1, 2004, pp, 1–19.
[11] Calise, F., Dentice d’Accadia, M., Palombo, A., Vanoli, L., "Simulation and exergy analysis of a hybrid Solid Oxide Fuel Cell (SOFC)–Gas Turbine System". Energy, 31, 2006, pp. 3278-3299.
[12] Calise, F., Palombo, A., Vanoli, L., "Design and partial load exergy analysis of hybrid SOFC–GT power plant", Journal of Power Sources, 158, 2006, pp. 225-244.
[13] Granovskii, M., Dincer, I., Rosen, M.A., "Exergy Analysis of gas turbine cycle with steam generation for methane conversion within solid oxide fuel cells", Journal of fuel cell Science & Technology, 5, 2008, p.031005.
[14] Motahar, S., and Alemrajabi, A. A, "Exergy based performance analysis of a solid oxide fuel cell and steam injected gas turbine hybrid power system", Int. Journal of Hydrogen energy, 34, 2009, pp.2396-2407.
[15] Williams, M., Horita, T., Yamagi, K., Sakai, N., and Yokokawa., "Basic Electrochemical Thermodynamic studies of Fuel Cell and Fuel Cell Hybrids", ASME J. Fuel Cell Sci.Technol., 6, 2009, pp.021303-1-4.
[16] Watchter, C., and Joos, F., "Steady state off - Design and Transient behavior of a Solid Oxide Fuel Cell/Gas Turbine Hybrid power plant with additional firing of the gas turbine combustor", ASME J.Eng. Gas Turbines Power, 131, 2009, pp.031701-1-9.
[17] Haseli Y., Dincer I., Naterera, GF., "Thermodynamic modeling of a gas turbine cycle combined with a solid oxide fuel cell", International Journal of Hydrogen Energy, 2008, PP. 5811–5822.
[18] Haseli Y., Dincer I., Naterera GF., "Thermodynamic analysis of a combined gas turbine power system with a solid oxide fuel cell through exergy", Thermochimica Acta, 480(2), 2008, PP. 1–9.
[19] Cohen H., Rogers G.F.C. and Saravabamutto H.I.H. "Gas Turbine Theory", Heritage Publishers,1996.
[20] Singhal SC., "Advances in solid oxide fuel cells", Journal of Solid State Ionics, 2000, PP. 188-200.
[21] Bejan A., Dincer I., Lorente S., "Miguel, Porous Media in Modern Technologies", Energy, Electronics, Biomedical and Environmental Engineering, Springer-Verlag, New York, 2004.
[22] Larminie A., Dicks A., Fuel Cell Systems Explained, 2nd edition, John Wiley & Sons Ltd., West Sussex England, 2003.
[23] Akkaya AV., "Electrochemical model for performance analysis of a tubular SOFC", International Journal of Energy Research, Vol. 31, 2007, PP .79-98.
[24] Song TW., Sohn JL., Kim TS., "Performance analysis of a tubular solid oxide fuel cell/gasturbine hybrid power system based on a quasi-two dimensional model", Journal of Power Sources, 2005, PP. 30-42.
[25] Shapiro H.N., Moran M.J., Fundamental of Engineering Thermodynamics, John Wiley & Sons., Motahar, S., 2006.
[26] Tse L., Galinaud F., Martinez-Botas RF., "Integration of solid oxid fuel cell into a gas turbine", ASME turbo expo power for land. Sea and Air, 2007.