Design and analysis of two input-one output converter based on quadratic boost converter to increase reliability of using renewable sources

Document Type : Power Article

Authors

Department of electrical engineering, faculty of energy, Kermanshah University of technology

Abstract

Nowadays, solar arrays and wind energy are considered as many renewable energy sources. These sources can deliver their energy to the grid or directly to the consumer. In power electronics, multi-input converters are commonly used to convert the energy of renewable energy sources into the power required by the grid. In this article, a high-gain non-insulated three-port converter based on a quadratic boost converter has been proposed. This converter includes two power supplies with controllable currents. This improves the performance of the converter and reduces the ripple current of the input sources. In addition, the proposed converter has two operating modes and can work with one or two voltage sources. To design a high-gain multi-input converter, first the structure and performance of the proposed converter are thoroughly analyzed and evaluated Then, using MATLAB software, the stability of the proposed converter is checked and the output voltage and input currents are controlled independently using the decoupling network method. Then the main equations are calculated theoretically and its performance in different duty cycles is investigated. Finally, the simulation results for different modes show the correct operation of the converter and controller.

Keywords

Main Subjects

References

[1] J. Zeng, X. Du and Z. Yang, "A Multiport Bidirectional DC–DC Converter for Hybrid Renewable Energy System Integration", IEEE Transactions on Power Electronics, Vol. 36, NO. 11, November 2021, pp. 12281-12291.
[2] R. Madhana, and Geetha Mani,"Power enhancement methods of renewable energy resources using multiport DC-DC converter: A technical review", Sustainable Computing: Informatics and Systems, Vol. 35, September 2022, pp. 2210-5379.
[3] T.V. P. Kumar, S. N. Mughal, R. G. Deshmukh, S. G. Kumar, Y. Kumar, and D. S. David, " A highly consistent and proficient class of multiport dc-dc converter based sustainable energy sources", Materials Today: Proceedings, Vol. 56, NO. 4, April 2022, pp.1758-1768. 
 [4] لیلا محمدیان، ابراهیم بابائی و محمد باقر بناء شریفیان، "ارائه شیوه جدیدی برای مدلسازی مبدل Cuk بر مبنای گراف سیگنال جریان و کنترل آن به روش مقاوم از نوع حساسیت ترکیبی"، نشریه مدلسازی در مهندسی، دوره 15، شماره 51، زمستان ، صفحه 275-288.
 [5] سید محمد مهدی میرطالئی و گلناز تاجمیر، "طراحی، مدلسازی و ساخت یک مبدل Source-Z بهره بالا برای کاربرد در اتصال منابع انرژی تجدیدپذیر به شبکه برق"، نشریه مدلسازی در مهندسی، دوره 16، شماره 53، تابستان 1397، صفحه 221-229.
 [6] آرمینه دستگیری، مجید حسین پور و علی سیفی، "مبدل DC-DC بدون ترانسفورماتور افزاینده با ضریب بوست باال مبتنی بر شبکه خازن سوئیچ شده فعال"، نشریه مدل سازی در مهندسی، دوره 19، شماره 66، پائیز 1400، صفحه 23-36.
[7] K. Yavuz, B. Yaşar, and B. Hacı, "Non-isolated high step-up DC/DC converters–an overview", Alexandria Engineering Journal, Vol. 61, No. 2, February 2022, pp. 1239-1250.
[8] W. Li and X. He, "Review of Non-isolated High-Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications", IEEE Transactions on Industrial Electronics, Vol. 58, NO. 4, April 2011, pp. 1239-1250.
[9] S. Srinivasan, R. Tiwari, M. Krishnamoorthy, M. P. Lalitha, and K. K. Raj, "Neural network based MPPT control with reconfigured quadratic boost converter for fuel cell application", International Journal of Hydrogen Energy, Vol. 46, NO. 9, February 2021, pp. 6709-6719.
[10] S. W. Lee and H. L. Do, "Quadratic Boost DC–DC Converter with High Voltage Gain and Reduced Voltage Stresses", IEEE Transactions on Power Electronics, Vol. 34, NO. 3, March 2019, pp. 2397-2404.
[11] P. Sharma, B. Singh, I. Khan, and N. Verma, "Mathematical modelling and performance analysis of high boost converter with coupled inductor", International Research Journal of Engineering and Technology, Vol. 4, NO. 5, May 2017, pp. 1223-1228.
[12] M. Veerachary, "Design and analysis of a new quadratic boost converter", National Power Electronics Conference (NPEC), Pune, India, 2017, pp. 307-313.
[13] F. Li and H. Liu, "A Cascaded Coupled Inductor-Reverse High Step-Up Converter Integrating Three-Winding Coupled Inductor and Diode–Capacitor Technique", IEEE Transactions on Industrial Informatics, Vol. 13, NO. 3, June 2017, pp. 1121-1130.
[14] K. Mohammadi. Tanha, V. Abbasi, and K. Mohammadi, "Multi‐application multi‐port DC–DC converter consisting six ports with four main operation modes", IET Power Electronics, Vol. 15, NO. 11, August 2022, pp. 1016-1031.
[15] R. Hu, J. Zeng, J. Liu, Z. Guo and N. Yang, "An Ultrahigh Step-Up Quadratic Boost Converter Based on Coupled-Inductor", IEEE Transactions on Power Electronics, Vol. 35, NO. 12, December 2020, pp. 13200-13209.
[16] N. Zhang, D. Sutanto, and K. M. Muttaqi, "A review of topologies of three-port DC–DC converters for the integration of renewable energy and energy storage system", Renewable and Sustainable Energy Reviews, Vol. 56, April 2016, pp. 388-401.
[17] M. B. Latran, and A. Teke, "Investigation of multilevel multifunctional grid connected inverter topologies and control strategies used in photovoltaic systems", Renewable and Sustainable Energy Reviews, Vol. 42, February 2015, pp. 361-376.
[18] S. Khosrogorji, M. Ahmadian, H. Torkaman, and S. Soori, "Multi-input DC/DC converters in connection with distributed generation units–A review", Renewable and sustainable energy reviews, Vol. 66, December 2016, pp. 360-379.
[19] Y. C. Liu, and Y. M. Chen, "A Systematic Approach to Synthesizing Multi-Input DC–DC Converters", IEEE Transactions on Power Electronics, Vol. 24, NO. 1, January 2009, pp. 116-127.
[20] Z. Rehman, I. Al-Bahadly, and S. Mukhopadhyay, " Multi-input DC–DC converters in renewable energy applications–An overview", Renewable and Sustainable Energy Reviews, Vol. 41, January 2015, pp. 521-539.
[21] Y.M. Chen, Y.C. Liu, and S. H. Lin, "Double-Input PWM DC/DC Converter for High-/Low-Voltage Sources", IEEE Transactions on Industrial Electronics, Vol. 53, NO. 5, October 2006, pp. 1538-1545.
[22] D. Liu, and H. Li, "A ZVS Bi-Directional DC–DC Converter for Multiple Energy Storage Elements", IEEE Transactions on Power Electronics, Vol. 21, NO. 5, September 2006, pp. 1513-1517.
[23] M. Babalou, M. Dezhbord, M. Maalandish, S.H. Hosseini, M.R. Islam, and H. Torkaman, "Modular DC‐DC converter with reduced current ripple and low voltage stress suitable for high voltage applications", International Journal of Circuit Theory and Applications, Vol. 50, NO. 11, July 2022, pp. 4027-4044.
[24] S. Rostami, V. Abbasi, and N. Talebi, "Ultrahigh Step-Up Multiport DC–DC Converter with Common Grounded Input Ports and Continuous Input Current", IEEE Transactions on Industrial Electronics, Vol. 69, NO. 12, December 2022, pp. 12859-12873.
[25] S. Rostami, V. Abbasi, N, Talebi, and T. Kerekes, "Three-port DC–DC converter based on quadratic boost converter for stand-alone PV/battery systems", IET Power Electronics, Vol. 13, NO. 10, August 2020, pp.2106-2118.
[26] S. Zhang, W. Qiao, and L. Qu, "A Decoupled Droop Control Strategy for Cascaded Multicell Inverter with Low-Frequency Modulation", IEEE Energy Conversion Congress and Exposition (ECCE), Detroit, MI, USA, 2022, pp. 1-6.
[27] R. R. Ahrabi, H. Ardi, M. Elmi, and A. Ajami, "A Novel Step-Up Multiinput DC–DC Converter for Hybrid Electric Vehicles Application", IEEE Transactions on Power Electronics, Vol. 32, NO. 5, May 2017, pp. 3549-3561.
[28] V. Abbasi, S. Rostami, S. Hemmati, and S. Ahmadian, "Ultrahigh Step-Up Quadratic Boost Converter Using Coupled Inductors with Low Voltage Stress on the Switches", IEEE Journal of Emerging and Selected Topics in Power Electronics, Vol. 10, NO. 6, December 2022, pp. 7733-7743.
[29] F. Nejabatkhah, S. Danyali, S. H. Hosseini, M. Sabahi, and S. M. Niapour, "Modeling and Control of a New Three-Input DC–DC Boost Converter for Hybrid PV/FC/Battery Power System", IEEE Transactions on Power Electronics, Vol. 27, NO. 5, May 2012, pp. 2309-2324.
Journal of Modeling in Engineering
Volume 21, Issue 74
November 2023
Pages 65-80

Files

History

  • Receive Date: 01 July 2022
  • Revise Date: 01 January 2023
  • Accept Date: 24 April 2023

Share

How to cite

Statistics