Numerical simulation of the flow field and heat transfer inside the channel with different dimensions of spindle obstacles in the presence of power-law non-Newtonian fluids

Document Type : Mechanics article

Authors

1 Ivanki University

2 Department of Mechanical Engineering, University of Eyvanekey, Semnan, Iran

Abstract

In this article, the analysis of the flow field and forced convection heat transfer of non-Newtonian fluids inside the channel with spindle-shaped obstacles is discussed. At first, after checking the governing equations and the boundary conditions of the problem, the grid independency has been evaluated. Then, the results of the present study have been validated for two cases of the Newtonian and non-Newtonian fluids with previous similar works. The effects of various parameters such as the effect of the arrangement of spindle obstacles, the effect of the obstacles diameter and the effect of the obstacles length have been investigated. Also, the effect of different power indexes of non-Newtonian fluid and its effect on drag coefficient and Nusselt number have been investigated. By examining the results, it was found that for all the mentioned parameters, the staggered arrangement of the spindle obstacles had a higher heat transfer rate than the ordered arrangement. The results of this research revealed that with the increase in the diameter and length of the obstacles, the amount of heat transfer from the obstacles decreases. Also, by increasing the diameter of obstacles, the pressure and friction drag coefficients increases. Finally, by examining the behavior of the non-Newtonian fluid of the power-law model, it was found that with the increase of the power index, the Nusselt number decreased and for shear thinning non-Newtonian fluids (n<1) less friction and pressure drops were obtained.

Keywords

Main Subjects


[1] A. Korichi and L. Oufer, "Numerical heat transfer in a rectangular channel with mounted obstacles on upper and lower walls," International Journal of Thermal Sciences, vol. 44, 2005, pp. 644-655.
[2]  A. Korichi and L. Oufer, "Unsteady heat transfer and pressure drop in channels with obtacles mounted on the upper and lower walls," Numerical Heat Transfer, Part A: Applications, vol. 48, 2005, pp. 711-729.
[3]  A. Bar-Cohen, "State-of-the-art and trends in the thermal packaging of electronic equipment," Journal of Electronic Packaging, vol. 114, 1992, pp. 257-270.
[4]] F. Zafar and M. M. Alam, "Flow structure around and heat transfer from cylinders modified from square to circular," Physics of Fluids, vol. 31,2019, pp. 083604.
[5] J.-j. Yin, T. Jia, D. Gao, and F. Xiao, "Numerical investigation of the patterns of the flow past nine cylinders at low Reynolds number," AIP Advances, vol. 10, 2020, pp. 085107.
[6] S. J. Lee, G. S. Mun, Y. G. Park, and M. Y. Ha, "A numerical study on fluid flow around two side-by-side rectangular cylinders with different arrangements," Journal of Mechanical Science and Technology, vol. 33, 2019, pp. 3289-3300.
[7]  N. Hosseini, M. Griffith, and J. Leontini, "The flow past large numbers of cylinders in tandem," Journal of Fluids and Structures, vol. 98, 2020, pp. 103103.
[8]  R. Mohebbi, "Natural Convection Fluid Flow and Heat Transfer a Square Cavity with a Heated Triangular Obstacle Using Finite Element Method," Journal of Modeling in Engineering, vol. 16, 2018, pp. 361-373.
[9] H. Rahman, S. Islam, W. Abbasi, and G. Nazeer, "A Numerical Study for Flow Around Three Square Cylinders in Triangular Arrangement," Iranian Journal of Science and Technology, Transactions of Mechanical Engineering, vol. 44, 2020, pp. 229-246.
[10] R. Tanner, "Stokes paradox for power-law flow around a cylinder," Journal of non-newtonian fluid mechanics, vol. 50, 1993, pp. 217-224.
[11]  J. M. Ferreira and R. P. Chhabra, "Analytical study of drag and mass transfer in creeping power law flow across tube banks," Industrial & engineering chemistry research, vol. 43, 2004, pp. 3439-3450.
[12] M. J. Whitney and G. J. Rodin, "Force–velocity relationships for rigid bodies translating through unbounded shear-thinning power-law fluids," International journal of non-linear mechanics, vol. 36, 2001, pp. 947-953.
[13]  N. Chaitanya and A. Dhiman, "Non-Newtonian power-law flow and heat transfer across a pair of side-by-side circular cylinders," International Journal of Heat and Mass Transfer, vol. 55, 2012, pp. 5941-5958.
[14] m. sharifi Asl, d. toghraie, and A. Azimian, "Numerical simulation of convective heat transfer in a turbulant non-Newtonian nanofluid flow through a horizontal circular tube," Journal of Modeling in Engineering, vol. 16, 2018, pp. 113-120.
[15] A. Sanyal and A. K. Dhiman, "Analysis of a channel-confined non-Newtonian shear-thinning flow past a pair of mildly heated side-by-side square cylinders," Numerical Heat Transfer, Part A: Applications, vol. 77, 2020, pp. 409-442.
[16]  M. K. Moraveji, S. M. H. Haddad, and M. Darabi, "Modeling of forced convective heat transfer of a non-Newtonian nanofluid in the horizontal tube under constant heat flux with computational fluid dynamics," International Communications in Heat and Mass Transfer, vol. 39, 2012, pp. 995-999.
[17]  G. R. Kefayati, "FDLBM simulation of mixed convection in a lid-driven cavity filled with non-Newtonian nanofluid in the presence of magnetic field," International Journal of Thermal Sciences, vol. 95, 2015, pp. 29-46.
[18] A. K. Dhiman and S. Kumar, "Non-Newtonian power-law flow across a confined triangular bluff body in a channel," Korean Journal of Chemical Engineering, vol. 30, 2013, pp. 33-44.
[19] R. Manica and A. L. de Bortoli, "Simulation of incompressible non-Newtonian flows through channels with sudden expansion using the power-law model," Trends in Computational and Applied Mathematics, vol. 4, 2003, pp. 333-340.
[20] R. P. Bharti, R. Chhabra, and V. Eswaran, "Two-dimensional steady Poiseuille flow of power-law fluids across a circular cylinder in a plane confined channel: wall effects and drag coefficients," Industrial & engineering chemistry research, vol. 46, 2007, pp. 3820-3840.
[21] W. Zhang, H. Yang, H.-S. Dou, and Z. Zhu, "Forced convection of flow past two tandem rectangular cylinders in a channel," Numerical Heat Transfer, Part A: Applications, vol. 72, 2017, pp. 89-106.
[22] A. Chandra and R. Chhabra, "Flow over and forced convection heat transfer in Newtonian fluids from a semi-circular cylinder," International Journal of Heat and Mass Transfer, vol. 54, 2011, pp. 225-241.
[23] R. P. Bharti, R. P. Chhabra, and V. Eswaran, "Steady forced convection heat transfer from a heated circular cylinder to power-law fluids," International Journal of Heat and Mass Transfer, vol. 50, 2007, pp. 977-990.
[24] A. A. Soares, J. M. Ferreira, and R. P. Chhabra, "Flow and Forced Convection Heat Transfer in Crossflow of Non-Newtonian Fluids over a Circular Cylinder," Industrial & Engineering Chemistry Research, vol. 44, 2005, pp. 5815-5827.