موتور سوئیچ رلوکتانسی خطی شش فاز جهت نیرو محرکه ی آسانسور

نویسندگان

دانشگاه سمنان

چکیده

در این مقاله موتور سوئیچ رلوکتانسی خطی شش فاز به عنوان یک جایگزین برای کاربردهای حمل و نقل عمودی مانند یک آسانسور خطی بررسی می گردد. ریپل نیرو محرکه موتورهای سوئیچ رلوکتانسی خطی زیاد بوده و استفاده از این موتورها در سرعتهای پایین، ریپل زیاد سرعت را به دنبال دارد. در واقع ساختار پیشنهادی شامل ترکیب سری شده ی دو موتور سوئیچ رلوکتانسی خطی سه فاز به گونه ای است که یک ساختار شش فاز با مشخصه ی گشتاور بهتر را تشکیل می دهد. در این مقاله تلاش می شود تا با استفاده از ساختاری شش فاز برای موتور سوئیچ رلوکتانسی خطی به پروفایل قابل قبولی در سرعتهای پایین 0.5m/s تا 1m/s که معمولا در آسانسورها به کار گرفته می شود دست یافت. نتایج شبیه سازی نیز برتری ساختار پیشنهادی برای سری کردن موتور های سوئیچ رلوکتانسی خطی در مقابل روش مرسوم را نشان می دهد. ساختار پیشنهادی ریپل سرعت را در سرعت 0.5 m/sو در بار کامل از 16.8 % به 1.24 % کاهش می یابد که بیانگر بهبود چشمگیر عملکرد با استفاده از ساختار شش فاز است.

کلیدواژه‌ها


عنوان مقاله [English]

SIX-PHASE LINEAR SWITCHED RELUCTANCE MOTOR DRIVE FOR ELEVATOR

نویسندگان [English]

  • S. Darabi
  • Y. Alinejad-Beromi
semnan
چکیده [English]

In this paper, a six-phase switched reluctance motor for applications such as vertical transportation in a linear elevator is considered. The driving force ripple in a linear switched reluctance is high and the use of these machines in low speeds are accompanying with high speed ripple. In fact, the proposed construction consists of the combination of two 3-phase series linear switched reluctance motors which make a 6-phase structure in order to provide a better torque specification. In this paper we tried to reach a better speed profile in low speeds (0.5 m/s up to 1 m/s) which is normally the case in elevators. The simulation results show the superiority of the proposed structure over conventional structure of the switched reluctance motors. The proposed structure reduces the speed ripple from 16.8% to 1.24% at 0.5 m/s. This result shows the high performance improvement of the 6-phase structure of the motor.

کلیدواژه‌ها [English]

  • Linear switched reluctance motor
  • Velocity controller
  • Force distribution function
 
[1]     H. S. Lim and R. Krishnan, “Ropeless elevator with linear switched reluctance motor drive actuation systems,” IEEE Trans. Ind. Electron., vol. 54, n. 4, August  2007, pp. 2209–2218.
[2]     Krishnan R, “ Switched reluctance motor drives modeling, simulation, analysis, design and applications,” London: CRC Press; 2001.
[3]     S.A. Nasar and I. Boldea, ”Linear Motion Electric Machines,” A Wiley-Interscience Publication John Wiley & Sons, Inc., 1976.
[4]     K. Adamiak, D. Barlow, C.P. Choudhury, P.M. Cusack, G.E. Dawson, A.R. Eastham, B. Grady, E. Ho, Y. Hongping, L. Pattison, and J. Welch, “The switched reluctance motor as a low-speed linear drive,” in Intl. Conf. on Maglev and Linear Drives,” Las Vegas, NV, pp. 39-43, May 1987. 
[5]     K. Takayama, Y. Takasaki, R. Ueda, T. Sonoda, and T. Iwakane, “A new type switched reluctance motor,” in Conf. Rec. of the IEEE IAS Ann. Mtg., Pittsburgh, PA, vol. 1, pp. 71- 78, October 1988.
[6]     K. Takayama, Y. Takasaki, R. Ueda, and T. Sonoda, “Thrust force distribution on the surface of stator and rotor poles of switched reluctance motor,” in IEEE Trans. on Magnetics, vol. 25, no. 5, pp. 3997-3999, September 1989.
[7]     P.M. Cusack, G.E. Dawson, and T.R. Eastham, “Design, control and operation of a linear switched reluctance motor,” in Canadian Conf. on Electrical and Computer Eng., Quebec, CA, pp. 19.1.1-19.1.5, September 1991.
[8]     C.T. Liu and Y.N. Chen, “On the feasible polygon classifications of linear switched reluctance machines,” in 1997 IEEE Intl. Electric Machines and Drives Conf. Rec., Milwaukee, WI, pp. TB1/11.1-TB1/11.3, May 1997.
[9]     C.T. Liu, K.S. Su, and M.H. Lee, “Three dimensional field and side-force design analyses of a transverse flux linear switched-reluctance machine,” in IEEE Trans. on Magnetics, vol. 34, no. 4, pp. 2132-2134, July 1998.
[10] C.T. Liu and N. Sheu, “Optimal pole arrangement design of a linear switched-reluctance machine for magnetic levitation and propulsion system,” in IEEE Trans. on Magnetics, vol. 32, no. 5, pp. 5067-5069, September 1996.
[11] Praveen V., “Design of Switched Reluctance Motors and Development of a Universal Controller for Switched Reluctance and Permanent Magnet Brushless DC Motor Drives”, Dissertation , Virginia Polytechnic Institute and State University, 2001
[12] T. J. E. Miller, “Optimal Design of Switched Reluctance Motors”, IEEE TRANSACTIONS ON INDUSTRIAL ELECTRONICS, VOL. 49, NO. 1, FEBRUARY 2002.
[13] Junghwan Chang, D. H. Kang, I.-A. Viorel, and Strete Larisa, “ Transverse Flux Reluctance Linear Motor’s Analytical Model Based on Finite-Element Method Analysis Results,” Digital 1202 IEEE Trans. on Magnetics, Vol. 43, No. 4, April 2007.
[14] J. Garcia Amorós, P. Andrada, “ Analytical approach to the design of a high-force density double-sided linear switched reluctance motor,” International Conference on Renewable Energies and Power Quality (ICREPQ’10) Granada (Spain), March, 2010.
[15] N.C. Lenin and R. Arumugam, “ A Novel Linear Switched Reluctance Machine: Analysis and Experimental Verification,” American J. of Engineering and Applied Sciences 3 (2): 433-440, 2010.
[16] FerhatDaldaban ,NurettinUstkoyuncu, “ A new double sided linear switched reluctance motor with low cost,” Energy Conversion and Management 47 (2006) 2983–2990.
[17] Deshpande U, “ Two-dimensional finite-element analysis of a high-force-density linear switched reluctance machine including three dimensional-effects,” IEEE Trans IndAppl 2000;36(4):1047–52.
[18] Seok-Myeong Jang, Ji-Hoon Park, Jang-Young Choi, and Han-Wook Cho, “ Analytical Prediction and Measurements for Inductance Profile of Linear Switched Reluctance Motor,”  IEEE Trans. on Magnetics, Vol. 42, No. 10, October 2006.
[19] Junghwan Chang, D. H. Kang, I.-A. Viorel, and Strete Larisa, “Transverse flux reluctance linear motor’s analytical model based on finite-element method analysis results,” IEEE Trans. on Magn., vol. 43, n. 4, April 2007, pp. 1201-1204.
[20] H.S. Lim, R. Krishnan and N.S. Lobo, “Design and Control of a Linear Propulsion System for an Elevator Using Linear Switched Reluctance Motor Drives,” IEEE Trans. Ind. Electron., vol. 55, n. 2, February 2008, pp. 534–542.
[21] N.S. Lobo, H.S. Lim and R. Krishnan, “Comparison of Linear Switched Reluctance Machines for Vertical Propulsion Application: Analysis, Design, and Experimental Correlation,” IEEE Trans. Ind. Appl., vol. 44, n. 4, 2008, pp. 1134–1142.
[22] Daldaban, F., Ustkoyuncu, N., "A novel linear switched reluctance motor for railway transportation systems", Energy Conversion and Management, 51(3), 465-469.
[23] X. Xue, K-W.E Cheng, Z. Zhang, J. Lin, and N. Cheung, “A Novel Method to Minimize Force Ripple of Multimodular Linear Switched Reluctance Actuators/Motors, ” IEEE Trans. Mag., vol. 48, no. 11, pp. 3859–3862, Nov. 2012.
[24] S. Darabi, Y. Alinejad-Beromi, “Extension of Architecture of Single-Pulse Controller to Drive Linear Switched Reluctance Motor” ,International Review on Modelling and Simulations (IREMOS) , vol. 5, no. 4, pp. 1517-1523, August 2012.